LibrePilot Forum
General Category => General Discussion => Topic started by: demigodspecial on June 15, 2017, 06:04:20 pm
-
Hello. I want to use my camera. I ticked Enable CameraStab. Mode in Gimbal tab. But i cant activate channel 5 and 6 in output tab. I did the steps in this document:
https://librepilot.atlassian.net/wiki/display/LPDOC/Camera+Stabilisation+Configuration
Can anyone help me?
-
Min, neutral, max to normal values, 1000,1500,2000 ?
Rettet den Luftraum, esst mehr Vögel.
-
Your min/neutral/max is 1000/1000/1000 and it should be 1000/1500/2000
Start by fixing that and pressing Save.
-
But i cant change neatural value. Its grey.
-
Set min/max as described in Wiki page.
Maybe reboot board and finally adjust neutral value.
-
Its ok now but channel 5 and 6 still grey. Any ideas how can i fix this?
-
Sorry, those are no longer grayed out. ???
What happens when you plug servos in to #5 and #6? I forget, but the FC may need to be in attitude mode and armed.
What about outputs 1 -> 4? What else is this FC being used for?
-
Sorry, those are no longer grayed out. ???
What happens when you plug servos in to #5 and #6? I forget, but the FC may need to be in attitude mode and armed.
What about outputs 1 -> 4? What else is this FC being used for?
Well the idea is two outputs for my contra motor. And the other channels for the camera but ı want to use them for to move flaps +-45degrees. Dont know if its work. Just bought this fc a couple days ago :).It dosent matter 5,6 or another two outputs. But still i dont know why 5,6 still now active. I did everthing viki says :/.