LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: youncester on March 06, 2016, 02:56:10 am

Title: No lights after using LibrePilot on Eachine Falcon 250
Post by: youncester on March 06, 2016, 02:56:10 am

So I updated the firmware and setup a new vehicle in Librepilot, and since then I am no longer able to turn my lights on using the switch on the side of the drone. However I have noticed that when I flip the switch it looks like it turns my VTX on and off. I am not sure what to do to get this fixed. Any help regarding this would be much appreciated.

Thanks

Title: Re: No lights after using LibrePilot on Eachine Falcon 250
Post by: Mateusz on March 06, 2016, 09:35:57 am

You need to configure accessory to the correct channel that is responsible for turning lights off/on.

Maybe it's similar to adding buzzer https://librepilot.atlassian.net/wiki/display/LPDOC/Adding+a+buzzer+to+Multirotor+frame