LibrePilot Forum
Users => Vehicles - MultiRotors => Topic started by: blackhawk2k7 on March 21, 2016, 01:44:29 am
-
Hi everyone! I haven't found an answer about this yet, but I have the FS-iA6b/FS-i6 hooked up to my cc3d via pwm, I have some oneshot125/active braking esc's en route with the aforementioned components already enabled. My question is; will I be able to enable that through my Cc3d? (will the 'Oneshot125' esc be 'clickable' when I go through the setup wizard again?) OR do I need to do something else to activate it?
Thank you!
-
Yes it asks you when going through the setup wizard
-
Using a CC3D you cannot enable Oneshot while using PWM input.
If you select PWM in Hardware tab, there is PWM+NoOneShot
(https://forum.librepilot.org/index.php?action=dlattach;topic=1140.0;attach=2121)
-
you need to connect the reciever to pin nr 1,2(+/-) and 8(cppm) to use oneshot
-
you need to connect the reciever to pin nr 1,2(+/-) and 8(cppm) to use oneshot
I think blackhawk2k7 still use PWM input.
For OneShot, all input types except PWM using CC3D, this means:
PPM, Sbus, Spektrum DSM, SRXL, JetiExbus, GraupnerHott
Too much choice coming :)
-
Hey guys thanks for the help! Still in the middle of the build and haven't hooked up my Rx yet, but pulled all the pins and swapped the white cable to pin-8.
Hooked up my oneshot/active braking esc's up and they started twitching when I calibrated them, so I dropped the min. output value to 950 and the twitching stopped.
Slim-builds are tough! This is my 4th slim iteration, but finally jumping to 4s.