39
« Last post by trust on August 05, 2022, 07:47:00 pm »
Here's a pix of one installed.
The mini Revo is on the bottom.
Two sets of 6 connectors - outputs plug in on the lower left of the PCB. I usually order them from 1-12 starting at the bottom.
Note ONLY the outputs connect to anything - power and ground are not connected from the mini REVO on the connector pin array.
The cPPM input, plus power gets connected to the bind input on the rcvr. (white/red/blk)
Power to the rcvr and then to the min-Revo comes from the 3 pin (only two used) connector (blk/green) middle left of the flitebrd.
All the servos and motor esc cables are on the bottom right.
Battery power to the flitebrd comes from the red (+) cable upper left, and blk (- under). I usually put 3mm connectors on these to make it easier to connect to whatever. I can supply both ends with 3mm, or just leave these as stubs.
Enclosed photo and schematic. Not shown on schematic is 2nd 5v output. This is a separate 5v regulator with +5/gnd connected to a 3 pin servo cable, that plugs into the end of the chain of servo connectors (see original photo).
There are 3 extra 3 pin connectors on the servo chain to allow for the power input (if used), and 2 other devices that may need power. Normally one also has the 1000uf cap connected also.