LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: clintonh on April 24, 2016, 11:12:18 pm

Title: oplink + cc3d evo
Post by: clintonh on April 24, 2016, 11:12:18 pm

Hi all, I freed up an evo flight controller and wanted to use it with an oplink.

I've successfully converted my transmitter to 433Mhz and use it with my Revo board.

On the evo, I get telemetry but can't get the transmitter setup wizard going.

I followed instructions and connected flexiport pin 3 on oplink to receiver port 8 on evo fc

I use main port for telemetry on both.

On the vehicle setup wizard I choose ppm and rapid sec.

Should I be connecting additional pins on the receiver port?
Am I missing something?

I've also tried port 3 on receiver with no luck.

I followed this wiki:

http://opwiki.readthedocs.org/en/latest/user_manual/oplink/cc.html

Title: Re: oplink + cc3d evo
Post by: anypis on April 24, 2016, 11:35:43 pm

Are you trying to match oplink with your board?

Title: Re: oplink + cc3d evo
Post by: f5soh on April 24, 2016, 11:44:35 pm

Please post Oplink tab screenshot from the Oplink connected to CC3D

Title: Re: oplink + cc3d evo
Post by: clintonh on April 25, 2016, 09:32:53 pm

Thank you for responding.

Title: Re: oplink + cc3d evo
Post by: f5soh on April 25, 2016, 10:08:13 pm

Try checking the "PPM_Only" on both sides, just to be sure.

Monitor the Receiver activity UAVO, you can see activity without calibrating.
System tab > UavoBrowser > Data > ReceiverActivity