LibrePilot Forum
Users => Vehicles - MultiRotors => Topic started by: filo on March 04, 2016, 06:22:14 pm
-
Dowloaded prog and placed spektrum ar 6210 on drone .
Dowloaded firmware -->ok
vehicle setup ok .
Nect :how do i wire the ar 6210 to the ccd3 ,ar 6210 is bind to dx9
How to i setup then my dx9 ?
Thanks in advance,
filo
-
https://www.youtube.com/watch?v=YK6Mth-j0KE this is for Another dsmx reciever but I Think it should work with yours too. I dont think you can run CPPM on your reciever.
-
:) :)It is flying !!
But , the only thing that is not working is the failsafe .
Trottle hold is ok .
But when sutting down the DX9, motors are still running .
Thanks in advance
filo
-
you have to set failsafe on both the reciever and the cc3d. the cc3d failsafe does not activate if the reciever failsafe works and default on most recievers will just hold the last commands if you loose reception.
-
Setting your RC failsafe is very important, that is if you don't want a fly-away.
If RC failsafe says "hold last stick positions" and it flies out of range while climbing. Bye bye.