LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: rogdodger1 on January 29, 2016, 07:03:11 pm

Title: Upgrade will not detect Revolution - do I have a knock off?
Post by: rogdodger1 on January 29, 2016, 07:03:11 pm

I bought a full Revo kit from Bangood. The upgrader will not recognize the board. Other cc3ds are fine. Does anyone have any ideas? It is the same on Mac and Windows.

Title: Re: Upgrade will not detect Revolution - do I have a knock off?
Post by: f5soh on January 29, 2016, 07:13:04 pm

What appends after a rescue ?

- hit Rescue button
- connect board


Led behavior after usb connect ?

Title: Re: Upgrade will not detect Revolution - do I have a knock off?
Post by: rogdodger1 on February 01, 2016, 02:07:09 am

I get the same behaviour. The green light flashes twice for less than a second and then for about 2 secs, no other lights. It then times out and replies that no connect. I have another revo controller and it works perfectly.

Thanks for the help, any other ideas.

Title: Re: Upgrade will not detect Revolution - do I have a knock off?
Post by: f5soh on February 01, 2016, 10:17:52 am

Its a hardware issue, the green led (power) is directly connected to a regulator output and should never blink.

Title: Re: Upgrade will not detect Revolution - do I have a knock off?
Post by: rogdodger1 on February 20, 2016, 05:40:17 am

Thanks guys, I had a bad board. Bang good replaced it and it works. Took some time though.

Thanks Again