LibrePilot Forum

General Category => General Discussion => Topic started by: samcoltsr on June 21, 2016, 12:17:39 am

Title: ESC'c on a outlaw 270 will not beep and can not save output to board
Post by: samcoltsr on June 21, 2016, 12:17:39 am

In the set up when its comes time to plug in the battery the esc's will not beep. Going thru the rest of the set up the motors will calibrate OK but when it comes to save the blue bar goes 1/2 way and that all. help

Title: Re: ESC'c on a outlaw 270 will not beep and can not save output to board
Post by: TheOtherCliff on June 25, 2016, 08:12:11 pm

ESC not beeping when it should is usually caused by no power going to the ESC or by no motor (or bad motor) attached to ESC.

The beep actually comes from the motor, and is usually fairly quiet when there is no prop on the motor.

Getting stuck on saving might be a hardware issue, might be that the board is sitting on something metal, might just need Firmware -> Halt and then Erase Settings.