LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: myflyer on June 10, 2016, 04:01:31 am

Title: After crash will not arm + Quad and tx won't connect
Post by: myflyer on June 10, 2016, 04:01:31 am

Hi everyone, had a low and fast crash two plugs on the receiver came un plugged. Replaced plugs in proper location. Now when I plug in the battery I get the beeps and lights on board and receiver. But it will not arm with the  transmitter. I even tried a different receiver. I also checked the  continuity of the wires from the receiver to the FC

Title: Re: After crash will not arm
Post by: onecooler on June 10, 2016, 06:33:55 pm

Hi!

Check your board status and transmitter inputs in GCS. Start troubleshooting from connecting to GCS is the "best LP practices". ;)

-K.

Title: Re: After crash will not arm
Post by: myflyer on June 10, 2016, 10:01:17 pm

Thank you, I had it hooked up and was doing a transmitter  calibration and it started beeping. Now it will not link to GSC. I only get two bars on the TX RX  meter tried to do a up date and it times out. Do you think the FC IS fried

Title: Re: Won't arm after crash
Post by: hwh on June 12, 2016, 06:52:02 am

This is the third thread you've created with the same question. Merged with other two threads.

Title: Re: After crash will not arm + Quad and tx won't connect
Post by: myflyer on June 12, 2016, 09:10:22 pm

Ok new at this

Title: Re: After crash will not arm + Quad and tx won't connect
Post by: myflyer on June 23, 2016, 02:40:31 am

I found the problem one of the pins on the receiver came loose installed a new one problem fixed thanks guys