LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: Xviews on April 17, 2016, 02:22:32 pm

Title: Ublox NEO-M8N with Compass and Libre Next Build Problem
Post by: Xviews on April 17, 2016, 02:22:32 pm

Hallo,

I'm just testing the new release :)

I have the Ublox NEO M8N with Compass in standard with 4 wires , it must then two additional wires for the MAG , this works very well , but now the problem

MAG only works if the board receives a reset through software (Firmware>Reset>Boot) with not a reset it won't work

Has anyone else this problem ?

I2C is Yellow/Orange


Sorry for my english   :-\

Title: Re: Ublox NEO-M8N with Compass and Libre Next Build Problem
Post by: cato on April 17, 2016, 02:50:05 pm

Sounds strange. I tested it on three different combination, and it always works as soon as INS13 fusion algorythm is selected.