LibrePilot Forum
General Category => General Discussion => Topic started by: gerardfernandes on August 24, 2017, 09:49:34 pm
-
Hi guys,
I've started today a new quad with cc3d!
I've set up all correctly, but I can't arm this little thing!
After various research on the internet, I can't find out where the problem is because the alarm gave me something that doesn't exist:
you can find in attachment the errors and the relative tab that wasn't like error suggest.
Thanks in advance to all the people that can help me!
Gerard
-
Hi, welcome.
Maybe you are using a multirotor ?
Manual mean direct relation between sticks and motors and cannot be used for multirotor, only fixed wing can handle "Manual" flight mode.
(https://forum.librepilot.org/index.php?action=dlattach;topic=3775.0;attach=6607)
-
Hi f5soh!
Thanks for the hint!
I've set-up Manual because the other fly mode gave strange command to my quadcopter.
EDIT: I've tried to set Stabilized1 but without any luck.
EDIT2: Oook, with the setting in attachment it works! THANKS! But it seems that only the rear motor spins and then it flips!
-
Double check the motor scheme according to the Vehicle tab (https://librepilot.atlassian.net/wiki/spaces/LPDOC/pages/5669255/Multirotor) (CW/CCW props)
Check the FC orientation and adjust the Virtual attitude (https://librepilot.atlassian.net/wiki/spaces/LPDOC/pages/2818092/CC+Attitude+Configuration) if needed.
-
Wow f5soh, you solve all of my problems! Thanks a lot!