LibrePilot Forum
Users => Vehicles - MultiRotors => Topic started by: Ford55 on January 05, 2017, 12:06:35 am
-
Hello, what do I need to get on screen display from my revo board, here is what I have right now:
Flysky FS-I6x
Flysky x6b receiver
TX TS832 transmitter
RX RC832 receiver
Fatshark dominator v3
Nexwave RF 5G8 receiver for the fatshark goggle
I think I need a miniOSD device, which one will be the best?
Also any suggestion or recommendation for how to plug all that are welcome
Thanks
Dan
-
Take a look here:
https://librepilot.atlassian.net/wiki/display/LPDOC/MWOSD+Setup
The "Micro" version is more compact.
Using a Revo controller, the best way is connect the Volt/Amp sensor to the controller:
https://librepilot.atlassian.net/wiki/display/LPDOC/Configure+a+Current-Voltage+sensor
-
I also have a voltage input on my x6b, what is the easiest way for my setup?
Sent from my iPad using Tapatalk
-
It depends on what you want to do. If you hook it to the receiver the voltage will display on your transmitter (assuming it has that capability). If you hook it to the revo as f5soh recommended it will display on the osd.
-
Good, I want it in the osd
Sent from my iPad using Tapatalk
-
Any suggestion on the best osd device I should buy?
Sent from my iPad using Tapatalk
-
The one we've been discussing in this thread is the Micro MinimOSD, it's inexpensive, very small, and it's probably the most used osd. There are fancier, more expensive ones, even ones built into PDB boards but this one hooks up to LP best.
Micro-MinimOSD on banggood (http://www.banggood.com/MICRO-MinimOSD-Minim-OSD-Mini-OSD-W-KV-Team-MOD-For-Naze32-Flight-Controller-p-990556.html?p=SO28133399239201512V) or just do a search for Micro MinimOSD and you should be able find lots of suppliers including on eBay.
-
Thanks for your help I just order that from a Canadian seller for 13$ cdn : https://www.dronesplus.ca/products/373f4a03341d
Will keep you updated when I install the parts.
Dan
Sent from my iPad using Tapatalk