LibrePilot Forum

General Category => General Discussion => Topic started by: lasercomp on January 18, 2017, 08:44:52 pm

Title: Proper voltage set on tester/buzzer
Post by: lasercomp on January 18, 2017, 08:44:52 pm

Hi all. I am fairly new to drone flying and am loving the hobby. I have a 250mm quad with a 3S 2200mah battery. I purchased a small battery tester and buzzer combo. I would like to know what voltage does battery drop down to until i stop flying and recharge? This little tester can be connected to balance wire of battery and it tells me the voltage of each cell and total voltage. I can set a threshold on the tester to buzz when the voltage dips below a certain reading. I dont know what that number should be. Any guidance is appreciated. Thank you


Sent from my SM-N920P using Tapatalk

Title: Re: Proper voltage set on tester/buzzer
Post by: TheOtherCliff on January 19, 2017, 02:19:18 am

I wrote some info and moved it to the wiki.
https://librepilot.atlassian.net/wiki/display/LPDOC/LIPO+battery+info

Title: Re: Proper voltage set on tester/buzzer
Post by: lasercomp on January 19, 2017, 06:30:24 am

Quote from: TheOtherCliff on January 19, 2017, 02:19:18 am

I wrote some info and moved it to the wiki.
https://librepilot.atlassian.net/wiki/display/LPDOC/LIPO+battery+info

Thank you so much for the in depth info. I read over everything twice and will read it one more time tomorrow morning. I will set my alarm buzzer accordingly. Btw, I purchased the buzzer/meter that tells me the voltage on each cell. Thanks again.

Sent from my SM-N920P using Tapatalk