LibrePilot Forum
Users => Vehicles - MultiRotors => Topic started by: rlambo on February 01, 2017, 03:46:24 am
-
im attempting to use the accessory switches on my flysky FS-t6 connected to a cc3d flight controller, however i can only get 2 of them working (on channels 6 & 7).
anybody know how to enable these extra switches.
TL:DR newbie cant use flysky switchs on cc3d
-
You can only use 2 unless you upgrade firmware mod on git github. However you can assign 2 switches to whatever switch you need to use via menu
Sent from my SM-G903F using Tapatalk
-
Normally, one switch is used for Flight Mode. Maybe another is used for Arming if you have a special setup.
Does the third switch even need to be known to the FC? Maybe you have a parachute release or something not related to flight. Is your receiver putting out PWM? Can you plug a servo straight into the extra receiver channel and test it?