LibrePilot Forum

General Category => General Discussion => Topic started by: mak24 on October 28, 2016, 04:29:51 am

Title: OPLink Noob Question
Post by: mak24 on October 28, 2016, 04:29:51 am

I finally have a clone F450, 1000KV, 1045 props with NAZA GPS copter flying decently.

For some reason, I keep getting a Mag warning that the Mag reading is off by 5%.  I thought I would try OPlink to configure Mag.  Is that a good idea?

This is my FC

http://www.banggood.com/OpenPilot-CC3D-Revolution-Revo-10DOF-STM32F4-Flight-Controller-Staight-Pin-p-1000068.html?rmmds=search

I am assuming that the antenna that comes with the FC is for the air side where it attaches to the revo board.

Please advise where could I get ground side oplink hardware.

Thanks in advance

Title: Re: OPLink Noob Question
Post by: jtrout19 on October 28, 2016, 05:22:57 am

https://hobbyking.com/en_us/openpilot-oplink-mini-ground-station-433-mhz.html

There ya go

Title: Re: OPLink Noob Question
Post by: zukenj on October 28, 2016, 02:36:11 pm

I have the same FC and I bought this Oplink

http://www.banggood.com/OpenPilot-OPLINK-MINI-CC3D-REVO-Universal-Transceiver-TX-RX-Module-Integrating-Remote-Controller-p-1000081.html?rmmds=myorder (http://www.banggood.com/OpenPilot-OPLINK-MINI-CC3D-REVO-Universal-Transceiver-TX-RX-Module-Integrating-Remote-Controller-p-1000081.html?rmmds=myorder)

The first one was bad, but Banggood sent me a new one and all is Ok.

Using the Oplink is the best to calibrate the Mag.

Please check the sticky post:
   
Revo AuxMag
https://forum.librepilot.org/index.php?topic=1110.0 (https://forum.librepilot.org/index.php?topic=1110.0)

Title: Re: OPLink Noob Question
Post by: mak24 on October 29, 2016, 04:11:49 am

Thanks very kindly for the online GCS and the video.  This is a wonderful community!