LibrePilot Forum

General Category => General Discussion => Topic started by: rmcferon on February 16, 2016, 11:49:14 pm

Title: Map Output Channel 5 to Accessory Switch?
Post by: rmcferon on February 16, 2016, 11:49:14 pm

I would like to use a receiver controlled switch to turn LEDs on and off. Can I map a transmitter switch to PWM output channel 5?

I'm using OP Link for PPM control so I don't have a receiver to plug the switch into.

Title: Re: Map Output Channel 5 to Accessory Switch?
Post by: f5soh on February 16, 2016, 11:52:09 pm

Like a mapping for buzzer, see this page:
https://librepilot.atlassian.net/wiki/display/LPDOC/Adding+a+buzzer+to+Multirotor+frame

Mapping is done in Vehicle tab.

Title: Re: Map Output Channel 5 to Accessory Switch?
Post by: rmcferon on February 16, 2016, 11:57:23 pm

Thank You. I searched for switch, map channels, output channel, led control... Never thought to search for a buzzer.